HomeMy WebLinkAboutSection 5-40-20 5-40.10
G. Pre-Application Conference Summary Sheet: A copy of the pre-application conference summary
sheet provided to the applicant at the pm-application conference.
H. Site Utilization Maps:Twenty-four 24"x 36"and two 81/2"x 11"site utilization maps specified
by the staff during the pm-application conference.During the pm-application conference,the Planning Office
may authorize an applicant to consolidate or delete specific maps which may not be applicable to a particular
development proposal. The 24"x 36"site utilization maps must be folded to fit within a legal sized folder
with the name of the application visible. Rolled site plans will not be accepted.
I. Copies of Application: Twenty-four(24) application copies. (Prior code § 5-401) ,
5-40.20 Final Plat
•
Copies of the final plat containing the information prepared in compliance with the standards established
in this section.
A. The Final Plat may be submitted for all or a portion of an area within a Detailed Subdivision
approved by the Board and it must conform to all provisions of the approval.
B. The Plat shall be legible and certified by a registered land surveyor.
C. The Plat shall be delineated by photographic methods on reproducible mylar twenty-four (24)
inches by thirty-six (36)inches in size with a one and one half(11/2) inch margin on the left side and a one.
half(rf) inch margin on the other sides, and drawn to a scale which is not less than 1 inch= 100 feet. The
Planning Office may permit the scale of the plat to be varied.
D. The point of beginning shall be indicated and a survey tie into a governmental monument or other
permanent marker established as reliable by the County Surveyor is required.
E. All bearings and distances of boundary lines shall be indicated outside the boundary line,not inside
with the lot dimensions.
F. If a Final Plat is revised, a copy of the former Plat marked in red to show the revisions shall be
provided for comparison purposes.
•
G. All blocks and all lots within each block shall be consecutively numbered.
H. All streets, trails, bikeways, bridle paths, ski trails, and drainage easements shall be designated
as such,names given to all streets, and bearings and dimensions given for all the above.
• I. On all curves, sufficient data must be given to enable the re-establishment of the curves:
1. Deflection of curve by arc definition;
2. • Radius of curve;
3. Tangent distances; and
329
•
5-40.20
4. Arc length by arc definition.
J. An excepted parcel shall be marked "not included in this plat" and the boundary described
accurately by bearings and distances.
K. The plat shall show all utility easements for consumer distribution within the subdivision.
L. All lands within the boundaries of the Plat shall be accounted for either by lots, paths, streets,
excepted parcels, parcels not owned by applicant, lands planned for public dedication and ownership or
common open spaces.
M. All lot dimensions shall be indicated.
N. Bearings shall be given for all Iot lines, except that bearings need not be given for interior lot
lines where the bearings are the same as those of both exterior lot lines.
0. Parcels not contiguous shall not be included in one Plat, nor shall more than one Plat be made
on the same sheet Contiguous parcels owned by different parties may be embraced in one Plat,provided that
all owners join in the dedication and acknowledgement.
P. The boundary of any special districts shall be shown on the Final Plat.In cases where corrective
measures have reduced or eliminated said boundary, the original and corrected boundary shall be shown on
the Final Plat
Q. The final plat shall include the following information:
1. Name of subdivision, north point, date and scale;
2. Name and address of owner(s) of record;
3. Total acreage of tract and total number of lots and size of each; and
4. Township, range, section, and quarter section, block and lot numbers.
R. Permanent reference monuments shall be set and marked for all Final Plats in compliance with
Section 38-51-101 C.R.S., 1973, any statute succeeding the same,with the following construction, location
and bonding procedures.
1. Permanent reference monuments (perimeter, block and lot) under normal geographic and
topographic conditions shall be No.5 steel rebar twenty-four(24) inches long with a metal cap at least one
and three eights (1-3/8) inches in diameter so that no more than four(4) inches protrudes from the ground
and mounded with stones.
2. There shall be one reference monument located at each public street intersection and said
monument shall be No.5 steel rebar eighteen(18)inches long with a metal cap at least one and three eighths
(1-3/8) inches in diameter and set flush with the finished road grade.
330
5-40.20
•
S. The surveyor making a Plat shall certify on the Plat that it is correct and that the perimeter
, monuments described in it have been placed as.described.
T. The Final Plat shall include only the information required by this Section 5-40.20. Advertising,
Corporate logos or any other information not specifically required on the Final Plat shall be prohibited.The
Final Plat shall include only those statements set forth in Section 5-40.50.
U. No'subdivision plat shall be finally approved by the Board of County Commissioners unless, at
the time of final approval, the subdivider provides certification from the County Treasurers' office that all
ad valorem taxes applicable to such subdivided land have been paid for all years prior to that in which
approval is given, or the subdivider escrows in cash the total amount of taxes due at the time of filing as
shown in the Treasurer's records or posts a surety bond with the County equal to 11 times the amount of
taxes due at the time of filing. (Prior code § 5-402)
5-4030 Improvements Agreement
If an improvements agreement is required,it shall be prepared in compliance with Section 3-180. (Prior
code § 5-403)
5-40.40 Conditions Report
A written report demonstrating compliance with all conditions of the Board of County Commissioner's
conceptual and detailed subdivision approval and resolving any outstanding technical problems. (Prior code
§ 5-404)
•
5-40.50 Final Plat Certificates
The Final Plat shall include the statements contained in this section. No modification of the required
statements is permitted except for clarification or technical reasons as may be recommended by the Planning
Director and approved by the Board or Commission approving said plat.Extraneous information,including
but not limited to, advertising, corporate names or logos is prohibited.
1. Certification of Dedication and Ownership
Know all men by these presents that being the owner(s), Mortgagee or
Lienholder of certain lands in Pitkin County, Colorado, described as follows:
containing acres more or less; have by these presents laid out, platted and subdivided
the same into lots and blocks as shown on this plat under the name and style of _
and do hereby dedicate to the public all rights-of-way and easements shown hereon for public
use.
•
331